![]() ![]() Procedure: Simultaneously press and hold down the MODE + 元 + R3 buttons (located on the T300 racing wheel’s base) for five seconds, and then release them. You can electronically swap the accelerator and clutch pedals. The racing wheel’s internal memory stores whether the pedals have been swapped around or not."įrom the tech support current firmware version 34 - T300_RS_GT_manual.pdf To do so, simply press the MODE button (6) for 2 seconds. "The T300 RS is also compatible with Thrustmaster pedal sets featuring 3 pedals (sold separately) these allow you to electronically swap the accelerator and clutch pedals. I have not been switching modes properly! These instructions have changed! Check it out: I'm about to freak out 'cause I have no idea what should I do and I can't race. Please help, I'll appreciate any kind of help. So I'm sure it's something related to my PC, but I have no idea. HOWEVER, I tested those pedals on 2 different computers and they worked perfectly fine. I took the whole PC apart and then rebuilt again (no result) tried different version of Windows 10 (no result) flashed my BIOS in case it's USB support problem (no result) replaced the USB cable (they're recognised but no input) changed USB ports (I tried all of them - no result) Calibration Software stops detecting them and I have to plug them again. The blue led light at the back is still there. ![]() ![]() They don't disconnect completely as the brake pedal remains working and they're visible in the Device Manager. The throttle pedal gets stuck at either 0 or 100% and there is nothing I can do. The issue is that my pedals randomly "disconnect" from my PC when not only playing, but just testing them in the Calibration Software. Hi, I use T-LCM pedals connected via USB together with G29 wheel (i don't have a thrustmaster wheel). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |